Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
441
Views
8
Helpful
5
Replies

VIC 4FXS/DID problem

acleri
Level 1
Level 1

‎04-11-2008 12:31 AM

Hi,

we have a cisco 2821 h323 voice gateway with an E1 interface, when we insert a new vic4fxs module the command related to the serial0/0/0:15 are not anymore accepted

****************

router1(config)#interface Serial0/0/0:15

^

% Invalid input detected at '^' marker.

****************

Router version: Version 12.4(13r)T

Any idea?

Thank you.

Labels:
0 Helpful
5 Replies 5

paolo bevilacqua
Hall of Fame
Hall of Fame

‎04-11-2008 01:55 AM

Likely you don't have enough dsp for bot E1 and 4 fxs, that requires 34 channels and you might have a pvdm2-32 only.

As a temporary workaround you can reduce the number of timeslots in pri-group.

Hope this helps, please rate post if it does!

acleri
Level 1
Level 1
In response to paolo bevilacqua

‎04-11-2008 02:14 AM

The E1 use 30 or 32 channels?

In case are 30 if I use VIC2-2FXS would be accepted?

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to acleri

‎04-11-2008 09:52 AM

30 channels, but you can reduce this number to 28 with pri-group command under controller E1, and nothing bad will happen.

0 Helpful

mmunoz-20
Level 1
Level 1

‎04-11-2008 10:02 AM

VIC4FSX/DID and VIC2-2FXS use the same number of resources

0 Helpful

paolo bevilacqua
Hall of Fame
Hall of Fame
In response to mmunoz-20

‎04-11-2008 12:28 PM

No, the four ports take 4 channels, and 2 ports takes two.

Customers Also Viewed These Support Documents