Digit Manipulation help

Unanswered Question
Apr 11th, 2008

Hi Guys,

I have just setup a new site and want to enable local dialling (0544 XXX XX)but across the WAN instead of the pstn as i am having problems with the local BRI circuits.

Basically i want to expand the local number to the full E164 (0039) on ccm.On the route list i have predot to discard the 0 for outside line.

Secondly,i get an awful noise on incoming calls on my BRI`s and therefore speech is barely audible.Site location in Italy.

Any help much appreciated !!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Jaime Valencia Fri, 04/11/2008 - 20:58

please provide an example of what you want to dial, what you want to send over the WAN and what's the destination's phone DN



if this helps, please rate


This Discussion