04-11-2008 06:17 AM - edited 03-13-2019 05:09 PM
hi guys
I have a problem in the configuration of the voices translation-rule
can someone help me?
my problem and that I have a line in entry (PRI) with did to two digit and internally I have three digit 5xx while the external number is actually 3989005xx to here nesun problem for the operation.
But I don't succeed in making to visualize the whole number in exit included theinside number
on the debug isdn is proposed the whole number, but I don't understand because is not visualized.
I have planned this configuration but not sò if it is correct
!
voice translation-rule 50
rule 1 / ^ \ (. * \) / / \1 / type unknown unknown
rule 2 / ^ \ (. * \) / /0\1 / type national national
rule 3 / ^ \ (. * \) / /00\1 / type international international
!
voice translation-rule 51
rule 1 / ^5 \ (.. \) / /3989005\1 /
!
voice incoming translation-profile
translate calling 50
!
voice translation-profile uscenti
translate calling 51
!
voice-port 0/0/0:15
translation-profile incoming entranti
local-alerting
cptone IT
bearer-cap Speech
!
dial-peer voice 20 potses
translation-profile outgoing uscenti
destination-pattern 0.T
port 0/0/0:15
!
dial-peer voice 10 potses
translation-profile incoming insert-zero
incoming called-number 3989005..
direct-inward-dial
no register e164
!
Solved! Go to Solution.
04-11-2008 10:25 AM
Hi,
You have asked this question already, beside for many would be hard to understand "nesun problem" :)
Check that sometime TI doesn't allow outgoig DID and you have to request they do.
04-11-2008 10:25 AM
Hi,
You have asked this question already, beside for many would be hard to understand "nesun problem" :)
Check that sometime TI doesn't allow outgoig DID and you have to request they do.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: