can't telnet Cisco2950 - can access connected devices

Unanswered Question

I have a 2950 switch that connect my servers from 3 VLANs to the main switch (Cisco 3560)

all my switches use VLAN1 with 192.168.74.x IP, the main switch is also configured with IPs on each of the other 3 VLANs

PCs on the network can telnet any 74.x switch, well - not that one 2950

the 2950 switch can only be accessed from the other switches

what would cause it to block non 74.x IPs from accessing it???

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Richard Burts Fri, 04/11/2008 - 10:21


The symptoms that you describe suggest that either the switch does not have a default-gateway configured or that the configured default-gateway is not correct. Can you post the switch config - or at least tell us what, if anything, the switch has for a default-gateway?




This Discussion