04-11-2008 10:51 AM
I have a d-link network camara. I connect it to my FE04 router (1811). How do I setup to have my people access to this camera by having them to enter ip address in internet with userid and password?
04-11-2008 12:21 PM
If it works as web server, configure a static nat translation:
ip nat inside source static tcp
80 interfaceI've put 800 as external port address so you can use 80 for router management if you want.
Then you can configure dynamic dns in the router so you always reach it.
Hope this helps, please rate post if it does!
04-11-2008 12:22 PM
how do I setup to have outside user enter userid and password before they can see my net camera?
04-11-2008 01:03 PM
Sorry, that is not supported. You have to rely on some PC software for that.
04-17-2008 10:24 AM
I got it to work, but user from outside and they want access to my camera, they have to enter as below: http://x.x.x.x:800
Two questions please:
Is the way I can convert my ip to other DNS?
How do I turn on firewall prevent from other access to my network?
Thanks,
04-21-2008 09:20 AM
dynamic dns:
http://www.cisco.com/en/US/docs/ios/12_4/ip_addr/configuration/guide/ht_ddns.html
As for the firewall, nobody can access your network because of nat. IOS also has firewall, but in most cases it is not necessary.
Hope this helps, please rate post if it does!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: