04-11-2008 08:17 PM - edited 03-03-2019 09:31 PM
Respected Sir,
I want to bind IP with MAC Address in cisco router, that client can't change their IP Address from the same MAC Address.
Plz.Help.
Regards,
Tarun
04-11-2008 08:42 PM
Hi, you had asked this question already, the answer is the same, disable dynamic arp under interface, and configure static arp entries in global config.
Hope this helps, please rate post if it does!
04-14-2008 02:19 AM
Sir,
according to your instruction, I have configrue. But not getting result. Configuration as follows-
interface GigabitEthernet2/0/4
description "Link To 55222"
switchport access vlan 7
switchport mode access
duplex half
speed 10
no arp arpa
---------------------
arp 10.230.8.10 0017.5982.b010 ARPA
Regards,
Tarun
04-14-2008 02:44 AM
This config goes on the router. It will not work on a switch unless it is a L3 switch and you enable routing.
04-14-2008 07:32 PM
sir,
This is Cisco 3750 switch. Am I need to changed the configuration.
Regards,
Tarun
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: