PIX PPTP

Unanswered Question
Apr 11th, 2008
User Badges:

Hi Guys!


I tried to configure my pix firewall to accept PPtP. But when i try to connect there's an error on the remote pc trying to connect. The error is: The remote computer did not respond. When i try to run sh vpdn on the pix, I see the Session username is unknown, state is estabd. This error occurs when i try to access the outside interface, but when i change the config vpdn enable to inside. theres no error on the remote pc whos trying to connect. Your help is much appreciated.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
smahbub Thu, 04/17/2008 - 13:42
User Badges:
  • Silver, 250 points or more

Verify the PPTP configuration on the PIX by using the pptp configuration guide present in the URL below:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080094a5a.shtml


check the following sections in the URL below for more information about the error message "remote computer did not respond"

1)PIX and PC Cannot Negotiate Authentication

2)PIX and PC Cannot Negotiate Encryption

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a0080143a5d.shtml#whatgowrong

Actions

This Discussion