MAC ACLs on load balancer

Unanswered Question
Apr 11th, 2008
User Badges:

Hi to all,


I wanted to know if Cisco has built load balancers which support MAC ACLs like on its switches. I know that some Cisco Load Balancers support standard IP and Named IP ACLs. But what abt standard MAC and Named MAC ACLs?


Thx in advance..


Warm regards,

Visham

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
didyap Thu, 04/17/2008 - 13:44
User Badges:
  • Silver, 250 points or more

You can configure the MAC ACL with the Cisco Access Point. To create the filters with the

Cisco Access Point CLI following the steps :

1) Log in to the AP through the CLI.

2) Issue the config terminal command to enter global configuration mode on the AP:

AP#configure terminal

3) Enter these commands to create the ACL:

Access-list 700 permit XXXX.XXXX.XXXX 0000.0000.0000

Access-list 700 permit XXXX.XXXX.XXXX 0000.0000.0000

Access-list 700 permit XXXX.XXXX.XXXX 0000.0000.0000

Access-list 700 deny 0000.0000.0000 ffff.ffff.ffff

!--- This command line has to be the last one, for every new MAC applied.

4) Apply this ACL to the radio interface:

AP#interface Dot11Radio 0

5) Issue the l2-filter bridge-group-acl end command.

6) Issue the write command.


I hope it will help you.

Actions

This Discussion