04-12-2008 05:19 PM - edited 03-11-2019 05:30 AM
Trying to configure remote access via Preshared secret..VPN client connects fine, but I am unable to connect to the internal LAN. When I turn on logging it is complaining that I have no translation rule outside interface to internal LAN. I have tried bypassing NAT via NAT 0 and ACL but no success.
Any ideas ??
Thanks Dave
04-13-2008 03:28 PM
so your nat 0 statement/acl has your LAN network range for the source address and your vpn client address range for the destination part?
is sysopt connection permit-vpn/ipsec turned on?
(sh run sysopt)
if not, is your outside-to-inside ACL allowing access from the remote access address range?
04-14-2008 02:45 AM
Thanks, it was the Nat 0 acl, had to swap it around and make the source address the internal LAN.
Cheers
Dave
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: