Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
691
Views
0
Helpful
3
Replies

ACS 4.1 problem

niro
Level 1
Level 1

‎04-13-2008 05:21 AM

I'm setting up ACS 4.1 and I'm running into a problemw ith command authorization on a PIX firewall. After all the configs on the PIX and setting up the group and device on the ACS 4.1 server, I'm able to login to the PIX with my windows username/password. Once I'm in, I'm able to get into enable mode (with the enable password), but once I'm in enable mode I can't type any command...I get command authorization failed. I check the ACS server and I see myself sucesfully log in in the logs, and then in the failure logs I see this:

04/13/2008 09:11:08 Author failed enable_15 Default Group 0.0.0.0 (Default) .. User unknown ..

Why would it try to authenticate enable_15?

What part of the config on the acs server am I missing?

Also...if I add an internal user in ACS named enable_15 and add him to the right group, everything works fine...but I don't think I should have to do that.

Labels:
0 Helpful
3 Replies 3

niro
Level 1
Level 1

‎04-14-2008 05:45 AM

Any ideas what this could be? Any help would be greatly appreciated!

Thanks

0 Helpful

niro
Level 1
Level 1
In response to niro

‎04-15-2008 08:22 AM

Shameless bump.

Somebody has to of run into this before.

0 Helpful

frankzehrer
Level 4
Level 4
In response to niro

‎04-15-2008 09:01 PM

Hi Mike,

your question is maybe better placed at

Netpro -> Security -> Firewalling

or

Netpro -> Security -> AAA

Good Luck

Frank

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents