04-14-2008 02:59 AM
Hi,
is it possible to leake a route from one VRF to another VRF on the Same PE. without having a RR in picture.
Regards,
Rajiv Mahuli
04-14-2008 04:18 AM
Dear rajivmahuli1982,
yes, but you must use the
import functionality of route-target and enable Border Gateway Protocol (BGP) on the router, This solution documented by Cisco in the below URL.
http://www.cisco.com/en/US/tech/tk436/tk832/technologies_configuration_example09186a0080231a3e.shtml
There is some changes in the below example as this is my self test for this document.
ip vrf VRF-A
rd 1:1
route-target export 1:1
route-target import 1:1
route-target import 2:1
!
ip vrf VRF-B
rd 2:1
route-target export 2:1
route-target import 2:1
route-target import 1:1
!
interface Serial1/0
ip vrf forwarding VRF-A
ip address 192.168.99.1 255.255.255.0
!
interface Serial1/1
ip vrf forwarding VRF-B
ip address 172.16.10.1 255.255.255.0
router bgp 1
!
address-family ipv4 vrf VRF-A
redistribute connected
!
address-family ipv4 vrf VRF-B
redistribute connected
Best Regards,
Mounir Mohamed
04-14-2008 04:40 AM
Hi Mounir,
thanks for the reply but what if there is no MPBGP peering at all if its a standalone router will this still work ??
04-14-2008 04:53 AM
yes even if no BGP neighbor configured.
Please rate helpful posts.
Best Regards,
Mounir Mohamed
04-14-2008 04:48 AM
Thanks i got the answer
thanks for the document.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: