cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
319
Views
5
Helpful
3
Replies

vms 2.3 performance issues

mladentsvetkov
Level 1
Level 1

Hi,

I have just installed VMS 2.3 on Solaris 8. The server is with 2GB RAM and 4GB SWAP.

I have serious performance issues with VMS, for example, opening the "Management Center for VPN Routers" screen takes 1-2 minutes.

I tried to improve the performance by removing the "IPS Management Center", but still VMS is really slow.

Would you please give me some advice about the problem?

Thanks in advance,

Mladen

1 Accepted Solution

Accepted Solutions

owillins
Level 6
Level 6

You must stop all processes, then restart again . I think this will work.

Installing the VPN/Security Management Solution (VMS) 2.3 on Solaris

http://www.cisco.com/en/US/docs/security/security_management/vms/2.3/install/guide/solaris/sqsapa.html#wp1009133

View solution in original post

3 Replies 3

owillins
Level 6
Level 6

You must stop all processes, then restart again . I think this will work.

Installing the VPN/Security Management Solution (VMS) 2.3 on Solaris

http://www.cisco.com/en/US/docs/security/security_management/vms/2.3/install/guide/solaris/sqsapa.html#wp1009133

I have restarted the processes a few times.

Could you please advise me to look for logs or other indicators for installation/configuration issues?

Although I have strictly followed the install guides...

Thanks in advance,

Mladen

Hi guys!

It was a connectivity issue. The switch port was configured with 10M duplex full settings. The throughput to the sun server was 10kbps!!!

After configuring the port with duplex auto speed auto everything was OK.

Regards,

Mladen

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: