Cisco Switch Configuration in GNS3

Unanswered Question
Apr 14th, 2008

please someone help me

how i can use cisco switch ios in GNS3

can i configure switch in GNS3 are not

reply

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Hi there

Not too familiar with GNS3, however I do use dynamips and GNS3 is just a GUI version of dynamips so it is much the same.

AFAIK there is a generic switch available in dynamips/GNS3 or you can add an NW 16ESW module to a 36xx router and use this for a lot of your L2 switching. It's not as good as having a full blown switch, but it's better that nothing.

Other than that, you can not load Catalyst IOS versions in GNS3/Dynamips as only router hardware is emulated.

HTH

Best Regards,

Michael

Actions

This Discussion