wlc 526 + ap 521 using dhcp on dlink but cannot get an ip

Unanswered Question
Apr 15th, 2008

i setup a wlc 526 with 2 521 aps, all of them are connected to the dlink DI-624+ ethernet router which is configured as DHCP. The wireless seems ok, but when a pc connected to the wireless network it was unable to receive dhcp from the dlink router.pls help me to solve this problem

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
drolemc Mon, 04/21/2008 - 06:34

Since the wireless part works fine between the WLC 526 and the 521 APs, the problem is with the other router which acts as a DHCP server. Check if DHCP has been configured correctly, or try using a different DHCP server.


Michael Ciulei Fri, 05/30/2008 - 02:40

At the wlc526 http page, go to controller->advanced->DHCP->deselect Enable DHCP Proxy.


For me it works fine.


shoulhafiz Sun, 06/01/2008 - 23:02

thanx man but that doesn't work for me.Finally I just configured a linux box as a dhcp server and everything is working just fine.thx.

dennischolmes Wed, 06/11/2008 - 04:30

Guys,


Some lesser valued dhcp servers will not accept dhcp by proxy as it is delivered by a controller on behalf of the client. To solve this issue then use this command at the cli


config dhcp proxy disable


This will allow your PCs to get a dhcp address from a dhcp server that does not support dhcp by proxy.

Actions

This Discussion