When I connect to ASA from L2 S/W using IPSEC Tunnel .

Unanswered Question
Apr 15th, 2008


When I connect to ASA from L2 Switch using IP sec Tunnel, I invocked the cli command, the session hang up, and then I can't L2 Switch , If I want to connect to L2 Switch again, I must reload L2 Switch.

Is this a ASA Security function?

I attached the configuration my customer site. the public ip was deleted due to security issue.

P.S What is a below command?

threat-detection basic-threat

threat-detection statistics access-list

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mchin345 Mon, 04/21/2008 - 10:04

To view the threat detection configuration, use the show running-config threat-detection command in privileged EXEC mode.

show running-config [all] threat-detection

option : all -- (Optional) Shows all threat detection commands, including the commands you have not changed from the default. For example, you can view the default rate limits for the threat-detection basic-threat command.


This Discussion



Trending Topics - Security & Network