04-17-2008 08:48 AM - edited 03-05-2019 10:26 PM
Hi, I want to connect a 2948G Switch with 3550 PoE switch together.
-2948G Switch (ver. 120-7.wx5.15a.bin)
3 Vlans
-3550 PWR PoE (122-25.SEE2)
3 Vlans
connected to internet
Requirement:
I want servers with diff. subnet connected on both switches to ping each other and to access internet too.
Pls. suggest a method with commands.
04-18-2008 02:59 AM
Hi,
You need to configure VTP for VLAN management between the switches, you need a trunk between the 2 switches. You need to configure layer 3 interfaces on the 3550 to handle the interVLAN IP traffic or pass this up to a router with ethernet sub-interfaces. You need to configure a default gateway for your internet traffic.
HTH.
04-20-2008 07:45 PM
HTH,
Unfortunately CAT 2948G cannot do trunking , only bridging , L3 (using BVI Interfaces)and also does encap dot1q, and Vlan's.
See the following link to find out how limited is : http://www.cisco.com/en/US/products/hw/switches/ps606/products_configuration_guide_chapter09186a008007e6ce.html
Knowing all the above how can we configure the connectivity between CAT 2948G and CAT 3550 PWR (knowing that is already connected to Internet) . Only servers/workstation connected to 2948G cannot connect to Internet.
Thanks for your help in advance.
Regards,
Maddox
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: