04-17-2008 05:58 PM - edited 03-05-2019 10:27 PM
Need help configuring port for full 1000. speed 1000 but duplex is set at auto. How do I change it?
04-17-2008 06:04 PM
you put the command "duplex full" in interface configuration mode.
04-17-2008 07:29 PM
I believe only full duplex is supported when speed is set to 1000 mbps. Hence, it should already be doing auto-full duplex with 1000 speed. The following CCO link seems to suggest the same.
From CCO
""Setting the Interface Duplex Mode
--------------------------------------------------------------------------------
Note When the interface is set to 1000 Mbps, you cannot change the duplex mode from full duplex to half duplex.
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/25sg/configuration/guide/sw_int.html
HTH
Sundar
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: