Remote Access VPN with IPSec on a stick

Unanswered Question
Apr 18th, 2008

Hello there,

I'm trying to establish a connection into the internet over a Remote Access VPN Tunnel.

The VPN-Client connects to Cisco PIX via IPSec-Tunnel and then connects to any web-server on the internet over the IPSec Tunnel.

This Connection is never established.

Normal IPSec-Traffic is no problem. I think I've got a problem with NAT. Where do I have to configure the NAT Rule for the VPN-Clients - on the "INSIDE" iface???

Other configurations like ACLs or "same-security-traffic permit intra-interface" are already done.

Please help

See ya


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
acomiskey Fri, 04/18/2008 - 05:32

same-security-traffic permit intra-interface

global (outside) 1 interface

nat (outside) 1

Make sure not to split tunnel, tunnel all traffic.

braulio.santos Sun, 09/14/2008 - 23:09

type route print in ur host and verify if the network or host than u need to gain acces is encrypted and maybe is split tunnel configuration


This Discussion