Remote Access VPN with IPSec on a stick

jens.becker · ‎04-18-2008

Hello there,

I'm trying to establish a connection into the internet over a Remote Access VPN Tunnel.

The VPN-Client connects to Cisco PIX via IPSec-Tunnel and then connects to any web-server on the internet over the IPSec Tunnel.

This Connection is never established.

Normal IPSec-Traffic is no problem. I think I've got a problem with NAT. Where do I have to configure the NAT Rule for the VPN-Clients - on the "INSIDE" iface???

Other configurations like ACLs or "same-security-traffic permit intra-interface" are already done.

Please help

See ya

Jens

acomiskey · ‎04-18-2008

same-security-traffic permit intra-interface

global (outside) 1 interface

nat (outside) 1

Make sure not to split tunnel, tunnel all traffic.

jens.becker · ‎04-18-2008

Yes, it works.

Thank you for the fast reply!!!

braulio.santos · ‎09-14-2008

type route print in ur host and verify if the network or host than u need to gain acces is encrypted and maybe is split tunnel configuration