Kenneth Mohammed Sun, 04/20/2008 - 05:42
User Badges:
  • Silver, 250 points or more

for your VWIC-1MFT-E1


controller E1 0/0/0

framing NO-CRC4

linecode (HDB3 or AMI)

pri-group timeslots 1-30


The above configuration automatically creates the following:


Interface Serial 0/0/0:15 (D channel interface)

no ip address

isdn switch-type (find out from telco what the switch type is)

isdn incoming-voice voice

no cdp enable


and also


voice-port 0/0/0:15


For your FXO's, you just need to put the statement "port 0/2/0" or "port 0/2/1" under the rest of the dial peers that you have marked "FXO pots dial-peer"


For the dial peers marked "E1 PRI pots dial-peer", add the statement "port 0/0/0:15". From there you should be good to go.


Hope that helps.

Kenneth Mohammed Sun, 04/20/2008 - 08:47
User Badges:
  • Silver, 250 points or more

correction to the above:


pri-group statement should read


"pri-group timeslots 1-31"

prajothpj Tue, 04/22/2008 - 02:36
User Badges:

Thanks

I will try this . is this configuration will stop outgoing calls through E1 interface . i have to recive all incoming calls through E1 to my opertor phone. and outgoing calls should go through FXO port. If you ca please give me the configuration steps it will be very helpful


Thanks &Regards

Prajoth

prajothpj Mon, 05/05/2008 - 21:36
User Badges:

Hi dear,

do you have any sample configuration the same scenario, like i have planning to go for PRI E1 line to receive calls and FXO for outgoing calls ,

how to create voice translation-rule for outgoing and incoming

how multiple calls can receive on operator phone.

Thanks

Prajoth


paolo bevilacqua Wed, 05/07/2008 - 02:56
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Translation-rules for what ?

With CME 4.3 you can receive up to 8 calls on a phone.

prajothpj Thu, 05/08/2008 - 05:29
User Badges:

Thanks

Like i have created hunt group to recive all Incoming calls from PRI E1 to operator phone . but im not sure about how it will know where to go . normally in FXO i ussed to mention connection plar opx XXX (extention ) number , here how it will work .

Regards

Prajoth

paolo bevilacqua Thu, 05/08/2008 - 05:32
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

On the hunt-group, configure the pstn called number as secondary.

Actions

This Discussion