ASA, multicast and PIM

Unanswered Question
Apr 20th, 2008

Hi all,

i've had a little problem with ASA conf in a multicast environment:

so....sparse mode on all interface involved (routers and ASA) RP is router (are connected with ethernet interfaces ruoters andn ASA and RP in anycast).

with ip pim bidir-enable on ASA i must do igmp static join on router interface towards ASA (source are on another router interface, receiver are on another ASA interface), source-if0-router-if1<igmpstatic>/-if1-ASA-if0-receiver

if i do on ASA 'no ip pim bidir-enable' and i remove on router static igmp all works....i cannot understand why :(:(

thk for all suggestions

Dan

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.

Actions

This Discussion