MGCP / CDR problem

denyshidaka · ‎04-20-2008

Guys I have just implemented a nerwork that do calls:

what we want to see in the CDR:

calls that are done:

old PBX phone - TDM -> PBX - QSIG/ ECMA -> Cisco 3845 - MGCP - > CUCM 6.1.1.200-3 - SCCP -> IP Phone

what we can see in the CDR:

IP Phone - SCCP - > CUCM 6.1.1.200-3 - MGCP -> CISCO 3845 - QSIG/ECMA- > PBX

Have in Mind all the calls can be completed we can use the route without problems.

But Now we need to bill some calls that will be done:

old PBX phone - TDM -> PBX - QSIG/ ECMA -> Cisco 3845 - MGCP - > CUCM 6.1.1.200-3 - H323-> Cisco 3845 - R2 -> PSTN

vmoopeung · ‎04-25-2008

I think you need to enable AAA and NTP on the H.323 gateway for CDR.

http://www.cisco.com/en/US/tech/tk1077/technologies_tech_note09186a0080094e72.shtml

denyshidaka · ‎04-25-2008

Thanks all,

I just got that the bugoff version of IOS I was using 12.4.3i was voice compatible but not exactly recommended fo IPT... due...

Changed the version to 12.4.9T7 and this seems to be working fine.

Problably we are going to use the tipo for the h323 for something else since I can not see in the CDR the channel and dial-peer used to complete the call.