Support for 1000 series in 5.0.148.0 ?

Unanswered Question
Apr 21st, 2008
User Badges:

I just read the release notes for WLC update 5.0.148.0 and I saw this line:


***

Cisco Aironet 1000 Series Access Points-The 1000 series access points are not supported for use with controller software release 5.0.148.0

***


Our entire network consists of 1010 and 1020 AP's (17 of them), does this mean that I can't update to 5.0.148.0 and that I'm stuck on 4.1.185.0 forever, or until I replace all of my APs ?

If Yes, what is the best AP to update to, to ensure a long lifespan, and is it worth the cost ?


/Dan

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
ericgarnel Mon, 04/21/2008 - 05:44
User Badges:
  • Gold, 750 points or more

the 1000 series are vxworks based and are no longer supported under 5.x code. EOS/EOL for the 1000 series was announced 9/07.


If you want n support, go with the 1252 radios, otherwise go for the 1242 radios. Those two models are the "long term" Cisco models.

We faced the same dilemma, but I do not see a very compelling reason to upgrade to 5.x yet.

hellbeach Mon, 04/21/2008 - 08:56
User Badges:

Hello Ericgarnel


A couple of follow ups on that:


1. I see that 1252 has 6 antennas, does this mean that these APs have a lot better coverage than 1010 and 1020 and I can get away with less APs ?


2. We have a WLC4402-25 today and we're using one GB port on it. If we would change to 1252 APs the theoretical bandwitdh would be approx six times greater, will a 4402 be enough to satisfy the needs even if we connect the second GB port or do we have to upgrade that aswell ?


/Dan

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode