Buy or Renew
Buy or Renew
Duo Security forums now LIVE! Get answers to all your Duo Security questions. Learn more
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
386
Views
0
Helpful
1
Replies

AIM-IPS deployment specifics

MaksimGura
Level 1
Level 1

‎04-21-2008 04:26 AM - edited ‎03-10-2019 04:04 AM

I'm planning to deploy IPS system using router 2821 and AIM-IPS module. Guys, could you help me to find out answers to the following questions:

1. Can the SUBinterface of the router interface be specified as command and control interface of the module using ip unnumbered command?

2. If external interface is configured in module as monitored interface and malicious traffic will be destined to this interface ip address (that is, this ip address will be as destination ip in the packets header). Is such traffic under control of AIM-IPS module?

3. Can BGP traffic be monitored by AIM-IPS module? How does it happen?

Labels:
0 Helpful
1 Reply 1

uchimaku
Cisco Employee
Cisco Employee

‎05-03-2008 11:44 PM

I shall answer Qn#2,

Traffic on any of the interfaces present on the router can be monitored by AIM IPS.

You need to go the interface configuration and type , "ids-service-module monitoring access-list " to enable monitoring.

Thanks

Udaya

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card