cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
526
Views
0
Helpful
5
Replies

Problems with Internet access and QoS please Check

I attach the output of the show_run command of my router that is connected to my ISP.

The access to internet is very slow I would like to have the opinion of any of you guys who have more experience and are expert on that subject.

Can you suggest to me what Can I do to optimize my problem. Are the QoS policies well designed?

All the serial interfaces are loaded as follow:

Serial0/0/1.156 is up, line protocol is up

Hardware is GT96K Serial

MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,

reliability 255/255, txload 84/255, rxload 250/255

I really appreciate your help

Thanks a lot

Regards

5 Replies 5

Edison Ortiz
Hall of Fame
Hall of Fame

You are limiting your output CIR to dialup connection (56kbps).

Is that what you intended ?

frame-relay cir out 56000

__

Edison.

No at all It is not my intention.

I didn't did this config. I would like to have the max Bandwith to give access to Internet to my users

Tahnks

Regards

What's the 'max' bandwidth you contracted for at each serial ?

__

Edison.

Hi Edison, I have contrzcted 2.048Mbps for each serial

Thanks for your help

Regards

Please modify your map-policy with the following:

map-class frame-relay Policing_Internet_IN

frame-relay fecn-adapt

frame-relay cir 2000000

frame-relay mincir 1500000

service-policy input Prueba

After this policy is applied, WWW will be limited to rate 1200000 bps, SMTP will be limited to rate 200000 bps and the remaining traffic will be limited to rate 200000 bps

HTH,

__

Edison.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: