I'm trying to set up a hub & spoke configuration using 2 spokes. I'm using multipoint sub-interfaces on all routers and frame-relay map commands with the 'broadcast' keyword. My problem is that I am only achieving connectivity between the hub and one of the spokes.
'sh frame pvc' at the hub shows that DLCI 101 is using Serial 0.101 but DLCI 201 is using the physical interface Serial 0 ???
My config at the hub:
interface serial 0
no ip address
frame-relay lmi-type cisco
interface serial 0.101 multipoint
ip address 192.168.10.2 101 broadcast
ip ospf network broadcast
frame-relay map ip 192.168.10.2 101 broadcast
frame-relay map ip 192.168.10.3 101 broadcast
Can I get both my frame-relay map commands to work under a single multipoint interface ?