04-21-2008 07:45 AM - edited 03-05-2019 10:31 PM
hi there, im trying to setup failover between two ASA 5510 and on inter e0/3 (on both ASA's) i have plugged a crossover a cable directly connecting them. Will this work to configure LAN based failover with stateful failover or do I need to connect the 2 asa's with a serial cable?
04-21-2008 08:18 AM
The below URL will be able to point you in the right direction, as there are a few answers to your question!
HTH.
04-21-2008 08:41 AM
andrew, thanks for the reply but having read that and looking at the diagram, it uses a serial cable and does not mention that straigh through ethernet cable can be used.
04-21-2008 10:00 AM
As there's no serial port on the ASA 5500 series appliances, you'll need to follow the LAN-based failover instructions in the Configuring Failover chapter of the Cisco Security Appliance Command Line Configuration Guide
http://www.cisco.com/en/US/docs/security/asa/asa80/configuration/guide/failover.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: