ericgarnel Mon, 04/21/2008 - 09:31
User Badges:
  • Gold, 750 points or more

You can do it from either. change the primary controller setting under the AP properties to point to the new controller and then save and reset the AP

marcellosozzo Mon, 04/21/2008 - 10:06
User Badges:

I have done as you suggested, specifing only as primary the desired WLC.

The LAP, which was configured by priming procedure, indeed still joints to same WLC, though its ip address was inserted in the controller list.

WLC software version is 5.0.148.0


best regards

marcello



ericgarnel Mon, 04/21/2008 - 10:58
User Badges:
  • Gold, 750 points or more

Have you tried reseting it back to defaults?

Scott Fella Tue, 04/22/2008 - 04:01
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 Wireless

Place the ap on the same subnet as the WLC you want it to join and set the WLC as the master. the ap will need an IP on the subnet and should be able to join this way. If this ap has a SSC, you will need to add that into the WLC.

ericgarnel Tue, 04/22/2008 - 07:39
User Badges:
  • Gold, 750 points or more

Verify that the 1st WLC is not setup as a "master" controller too

Actions

This Discussion

 

 

Trending Topics: Other Wireless Mobility

client could not be authenticated
Network Analysis Module (NAM) Products
Cisco 6500 nam
reason 440 driver failure
Cisco password cracker
Cisco Wireless mode