Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
713
Views
0
Helpful
8
Replies

Movinn a LAP from a WLC to another WLC

marcellosozzo
Level 1
Level 1

‎04-21-2008 09:00 AM - edited ‎07-03-2021 03:45 PM

Is it possible to move a LAP associated to a WLC to another WLC?

Can i do it from WLC or WCS?

thanx

marcello

Labels:
0 Helpful
8 Replies 8

ericgarnel
Level 7
Level 7

‎04-21-2008 09:31 AM

You can do it from either. change the primary controller setting under the AP properties to point to the new controller and then save and reset the AP

0 Helpful

marcellosozzo
Level 1
Level 1
In response to ericgarnel

‎04-21-2008 10:06 AM

I have done as you suggested, specifing only as primary the desired WLC.

The LAP, which was configured by priming procedure, indeed still joints to same WLC, though its ip address was inserted in the controller list.

WLC software version is 5.0.148.0

best regards

marcello

0 Helpful

ericgarnel
Level 7
Level 7
In response to marcellosozzo

‎04-21-2008 10:58 AM

Have you tried reseting it back to defaults?

0 Helpful

marcellosozzo
Level 1
Level 1
In response to ericgarnel

‎04-21-2008 11:16 AM

Yes, the reset has be done in all the possible ways.

marcello

0 Helpful

ddmoe
Level 1
Level 1
In response to marcellosozzo

‎04-21-2008 11:44 AM

Does the AP have a self signed certificate? If yes, make sure it is on both WLC's.

0 Helpful

Scott Fella
Hall of Fame
Hall of Fame
In response to ddmoe

‎04-22-2008 04:01 AM

Place the ap on the same subnet as the WLC you want it to join and set the WLC as the master. the ap will need an IP on the subnet and should be able to join this way. If this ap has a SSC, you will need to add that into the WLC.

-Scott
*** Please rate helpful posts ***
0 Helpful

ericgarnel
Level 7
Level 7
In response to marcellosozzo

‎04-22-2008 07:39 AM

Verify that the 1st WLC is not setup as a "master" controller too

0 Helpful

Saurav Lodh
Level 7
Level 7

‎07-11-2013 11:40 PM

https://supportforums.cisco.com/thread/2025341 , please follow

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card