NetFlow on a Frame Relay - sub interface

Unanswered Question
Apr 21st, 2008
User Badges:

I have a frame relay sub interface which is doing frame-relay payload-compression packet-by-packet. Is it possible to configure netflow on this interface. Eventhough I configure on the main netflow entries pertaining to these interfaces are not available in the netflow cache. Please help

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
tstanik Fri, 04/25/2008 - 12:36
User Badges:
  • Bronze, 100 points or more

To configure NetFlow, first configure the router for IP routing Use the following commands beginning in global configuration mode:

interface type slot/port-adapter/port (Specify the interface, and enter interface configuration mode.)

ip route-cache flow (Enable NetFlow).


For the further configuration of the Frame Relay follow the link :

http://www.cisco.com/en/US/docs/ios/12_0/wan/configuration/guide/wcfrelay.html#wp5157


linker.team Sun, 04/27/2008 - 21:27
User Badges:

Hi,


Thanks for your reply. Other frame relay interfaces which are not doing payload compression are available in the netflow cache entries. The only problematic interfaces are compression interfaces. Is it a limitation?

yjdabear Mon, 04/28/2008 - 06:24
User Badges:
  • Gold, 750 points or more

Yes, unfortunately NetFlow does not support compression at this point.

Actions

This Discussion