igmp join group

Unanswered Question
Apr 21st, 2008
User Badges:

I have a WS-C3560G-48TS-S with IOS version 12.2(25)SEE.It will not take the command "igmp join group" when using multicast routing.Please tell me what may be the solution to enable multicast routing on that devices.the matter is very urgent.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
ketimun123 Wed, 04/23/2008 - 03:20
User Badges:

In 12.2(25)SEE, all feature-set should support this command.

Do you want to use this command ?

ip igmp join-group

What error-message do you get ?

CSCO10685316 Wed, 04/23/2008 - 21:40
User Badges:

after interface config mode when I am giving ip igmp it is not showing join-group. After ip igmp i am getting three option




Pls response

ketimun123 Thu, 04/24/2008 - 09:56
User Badges:

As of your listed config-options, I assume you try to configure a Layer 2 port.

If you change it to a Layer 3 port the command should work .

If you still have the issue, please attach sh ver and sh run.



This Discussion