04-21-2008 11:34 PM - edited 03-05-2019 10:32 PM
I have a WS-C3560G-48TS-S with IOS version 12.2(25)SEE.It will not take the command "igmp join group" when using multicast routing.Please tell me what may be the solution to enable multicast routing on that devices.the matter is very urgent.
04-23-2008 03:20 AM
In 12.2(25)SEE, all feature-set should support this command.
Do you want to use this command ?
ip igmp join-group 225.1.1.1
What error-message do you get ?
04-23-2008 09:40 PM
after interface config mode when I am giving ip igmp it is not showing join-group. After ip igmp i am getting three option
1)filter
2)max-group
3)snooping
Pls response
04-24-2008 09:56 AM
As of your listed config-options, I assume you try to configure a Layer 2 port.
If you change it to a Layer 3 port the command should work .
If you still have the issue, please attach sh ver and sh run.
Thanks
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: