POE for Aironet 1131 on Catalyst Express 500

smallore_4plus · ‎04-22-2008

Hi all,

we are using 3 AP Aironet 1131 (Version 12.4(10b)JA3) in a WDS. All are connected to a Switch Catalyst Express 500 to receive their Power. The Problem is they work for some time and the the AP reloads without further errormessage.

Speed and Duplex mode are fixed on Switch and AP-Side. Does anybody now this problem or can give me a hint?

Thanks in Advance

Alex

drolemc · ‎04-28-2008

This can happen if power settings are configured incorrectly on the AP. Ensure that the correct parameters are configured. Here is a link which explains how to configure power on APs.

http://www.cisco.com/en/US/docs/wireless/access_point/12.3_2_JA/configuration/guide/s32frst.html#wp1103896

Also, try disabling CDP and check if you are seeing the issue again.

smallore_4plus · ‎04-28-2008

Hi,

thanks for the hints, but i found the issue: The problem was a damaged network cable. After exchanging the cable, all is working properly.