Greetings.

We have a Cisco 10000PRE2 router running in ISG mode with the following config:

Cisco IOS Software, 10000 Software (C10K2-P11-M), Version 12.2(31)SB11, RELEASE SOFTWARE (fc3)

NAME: "Chassis", DESCR: "C10000 Edge Service Router (ESR) Chassis"

PID: ESR10008-CHASSIS , VID: V02 , SN: FOX10461842

NAME: "module 1/0", DESCR: "1 port Gigabit Ethernet Half-Slot Line Card"

PID: ESR-HH-1GE , VID: V01 , SN: CAT1039530R

NAME: "module 2/0", DESCR: "1 pt Gigabit Ethernet line card (requires a GBIC)"

PID: ESR-1GE , VID: , SN: CAT10465NRH

NAME: "module 3/0", DESCR: "1 pt Gigabit Ethernet line card (requires a GBIC)"

PID: ESR-1GE , VID: , SN: CAT10465NM8

NAME: "RP A", DESCR: "Performance Routing Engine"

PID: ESR-PRE2 , VID: V02 , SN: CAT10455FYE

NAME: "RP A flash card 0", DESCR: "Flash Card"

PID: ESR-PRE-MEM-FD128 , VID: , SN:

NAME: "power-supply 0", DESCR: "AC power entry module for ESR10008"

PID: ESR-PWR-AC , VID: , SN:

NAME: "fan-tray", DESCR: "BLOWER ASSEMBLY FOR ESR10008"

PID: ESR-BLOWER , VID: , SN:

No matter how i tried, i could not get two or three of these network cards working int GigabitEtherChannel mode, however, this link: http://www.cisco.com/en/US/docs/ios/12_2sb/feature/guide/sbcelacp.html says it's possible. Ports (including Port-Channel interface itself) go up, but no frames are passing through. Had anyone success with this matter?

Or, does anyone know, if 10G module is planned for this chassis? I have nearly 900M of traffic passing through it, and desperately need some reserve.

Thanks a lot!