VG224 configuration with CUCM 6.1

zzbronski · ‎04-23-2008

I have installed a vg224 voice gateway along with our cucm6.1 and have been unable to get a analog phone to work with it. The vg224 has been entered into the cm administration under gateways with sccp. I have attached a analog phone to the vg224 and configured it in the cm adminstration with a number assigned. What else am I missing to get this to work. I have only had experience with the older vg248 which was not ios based.

kelvin.blair · ‎04-23-2008

You need to make sure you configured sccp connection on that vg224. Make sure that it is registered to call manager. Here is a sample configuration of the vg224 configured as a sccp gateway in call manager.

sccp local FastEthernet0/0

sccp ccm X.X.X.X identifier 10

sccp ccm X.X.X.X identifier 12

sccp

!

sccp ccm group 1

associate ccm 10 priority 1

associate ccm 12 priority 2

stcapp ccm-group 1

stcapp

dial-peer voice 1 pots

service stcapp

port 2/1

dial-peer voice 2 pots

service stcapp

port 2/2

etc....

Do a "show sccp" to see if the device is registered to call manager.

zzbronski · ‎04-23-2008

Thank you very much. That resolved the problem.

Sushil Kumar Katre · ‎04-23-2008

Rated Kelvin's post based on bronski's reply.

kelvin.blair · ‎04-24-2008

Thanks!