NetFlow on MPLS PE

Unanswered Question
Apr 23rd, 2008

Hi,

I have a customer requiring NetFlow data sent to them from the PE router. Is there a way to enable NetFlow only for a specific VRF?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Chuan Liu Tue, 04/29/2008 - 17:51

Hi Carlos,

Thanks a lot for the response. It is quite helpful. This doc describes a case in which NetFlow is sent to provider collector.

I want the NetFlow source interface and destination collector address are in the same VPN so that it can be sent to the customer collector. Otherwise, because of IP address space overlapping, it's quite complex to 'NAT' addresses to get to the customer destination via the backbone netowrk.

Thanks again.

Actions

This Discussion