Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
295
Views
0
Helpful
3
Replies

Need help understand-work with RJ 21 on 6509 Switch SUP 720

m-abooali
Level 4
Level 4

‎04-23-2008 07:20 PM - edited ‎03-05-2019 10:34 PM

Hi,

Although I have asked these question in my two earlier posting I still need some assistance understanding working with RJ21 interfaces on a Cisco 6509 switch.

I have tried to find documentation on these type of interfaces on the Cisco site and lese where but nothing so far!

I am greatful if someone could point me to some documentation on working with RJ21 on 6509 since I need to create some PVLANs on it. All i know is that each interface supports 12 ethernet ports!

Regards,

Mike

Labels:
0 Helpful
3 Replies 3

jcoke
Level 3
Level 3

‎04-23-2008 07:58 PM

Like RJ-45, RJ-21 is just the physical interface connector used. Configuring the interfaces on it is no different than on a blade with normal RJ-45 interfaces.

0 Helpful

m-abooali
Level 4
Level 4
In response to jcoke

‎04-23-2008 08:26 PM

so, its just a matter to go under the interface say 5/1 through 12 and assign those 12 ports say to a community PVLAN?

nothing extra? no special considerations, restrictions? etc?

Regards,

Mike

0 Helpful

jcoke
Level 3
Level 3
In response to m-abooali

‎04-23-2008 08:31 PM

Pretty much.

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card