Please can you tell me how we can connect up 2 switches to a RPS 2300.
In what order and what lights do we see on the RPS. Also which state should the RPS be - active or standby? Either the switches are up and running or not.
Also, in what order do we shut the switches and RPS down if we need to remove the RPS.
Is this order correct:
1. At first, to press the Active/Standby button on the switch to place the RPS in Standby mode so that the Active/Standby LED light is blinking amber, ( wait for some time) and then to press it again so that the Active/Standby LED light is now green (while doing this, the switches may reboot)
2. If option 1 does not work,
a. Press the Active/Standby button to put the RPS in standby mode. Active/Standby button LED light should show blinking amber
b. Shut down the RPS and remove the RPS cables from the switches (Again the switches may reboot)
c. Make sure that the Switches are up and running and in a steady state
d. Turn on the RPS
e. Put RPS in standby mode by pressing the Active/Standby button. The LED light should show blinking amber
f. Connect the cables back
g. Press the Active/Standby button to put the RPS in Active mode. Active/Standby button LED light should show steady green
Thanks