Solved: International Calling - Cisco Community

246

Views

0

Helpful

1

Replies

I am trying to wrap my mind around NANP and the way it tags a call as being "international" "local" "long distanceâ€.

I have an issue where my provider needs me to strip the 011 from a call if I am tagging the call as "international" when it is sent out of the gateway.

I thought I could create a RP with 4011. and strip the "pre dot" but the call manager then recatgorizes the call as "National" instead of "international".

Can someone explain how this is normally setup?

Should I strip the 011 at the GW (H323), if so how do I do this?

Cm 4.1.3sr5d

1 Accepted Solution

Accepted Solutions

if you have the dial-peer pots just make the destination pattern 9011T all the exact matches will be dropped, you can also modify the plan on the GW

Voice Translation Rules

http://www.cisco.com/en/US/partner/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

Number Translation using Voice Translation Profiles

http://www.cisco.com/en/US/customer/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate

View solution in original post

1 Reply 1

if you have the dial-peer pots just make the destination pattern 9011T all the exact matches will be dropped, you can also modify the plan on the GW

Voice Translation Rules

http://www.cisco.com/en/US/partner/tech/tk652/tk90/technologies_tech_note09186a0080325e8e.shtml

Number Translation using Voice Translation Profiles

http://www.cisco.com/en/US/customer/tech/tk652/tk90/technologies_configuration_example09186a00803f818a.shtml

HTH

javalenc

if this helps, please rate

HTH

java

if this helps, please rate