sundar.palaniappan Thu, 04/24/2008 - 15:47
User Badges:
  • Green, 3000 points or more

Are you asking about assigning the context to a failover group? If it is then the command is 'join-failover-group ' under the context mode. This command should be supported in Version 8.x. If you have a different requirement could you clarify that.


HTH


Sundar



Gerard Gacusan Thu, 04/24/2008 - 20:21
User Badges:

got it...I need to enable multiple context first with this command, "mode multiple"


these are now available commands:

failover group 1

failover group 2


any basic config for A/A failover would be appreciated. Thanks ...









Actions

This Discussion