Are you asking about assigning the context to a failover group? If it is then the command is 'join-failover-group ' under the context mode. This command should be supported in Version 8.x. If you have a different requirement could you clarify that.
got it...I need to enable multiple context first with this command, "mode multiple"
these are now available commands:
failover group 1
failover group 2
any basic config for A/A failover would be appreciated. Thanks ...
Getting Started
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:
