lms 2.6 device fault manager thresholds total bandwidth

Answered Question
Apr 24th, 2008

Hi


Would you please explain what does this mean for the Error traffic threshold:


"The upper threshold for packet rate, expressed as a percentage of the total bandwidth"


Does "total bandwidth" refer to the interface speed - 100M, 1G etc? Or it refers to the total current interface load?


This question is valid for all thresholds where "total bandwidth" is referred:

Broadcast threshold

Error traffic threshold

Utilization threshold


Thanks in advance,


Mladen

Correct Answer by Joe Clarke about 8 years 10 months ago

Max speed is just another way of stating ifSpeed. Though faster interfaces require DFM to look at ifHighSpeed.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (3 ratings)
Loading.
Joe Clarke Fri, 04/25/2008 - 10:13

Total bandwidth refers to the ifSpeed or max speed of the interface.

Joe Clarke Fri, 04/25/2008 - 10:24

I should also note that even if the HighErrorRate event says "total bandwidth" it is built based on the current traffic rate.

mladentsvetkov Sat, 04/26/2008 - 09:14

Thanks,


For ifSpeed, it is clear - comes from the IF-MIB. But what about the "max speed"?


Regards,


Mladen

Correct Answer
Joe Clarke Sat, 04/26/2008 - 09:19

Max speed is just another way of stating ifSpeed. Though faster interfaces require DFM to look at ifHighSpeed.

Actions

This Discussion