Rate Limit How to?

Unanswered Question
Apr 26th, 2008
User Badges:

i have a cisco 3845 router where port gi 0/0 is connected to internet and gi 0/1 is to lan. WCCP is enabled on port gi 0/0 redirecting out. now if i want to rate limit a single user or a group it does not work, but if i rate limit my proxy it works - but for all users. is there any solution to it that i can rate limit any user with WCCP turned on? urgent help needed.

Note: i'm using real IP, no natting. and i'm rate limiting inbound traffic to gi 0/0.


  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
mounir.mohamed Mon, 05/05/2008 - 06:32
User Badges:
  • Gold, 750 points or more

HI Cupid,

Just idea and need to be tested.

I think You can use WCCP redirect-list to deny set of hosts, then rate-limit them.

Please rate helpful posts

Best Regards,

Mounir Mohamed


This Discussion