04-26-2008 02:24 AM - edited 03-03-2019 09:42 PM
i have a cisco 3845 router where port gi 0/0 is connected to internet and gi 0/1 is to lan. WCCP is enabled on port gi 0/0 redirecting out. now if i want to rate limit a single user or a group it does not work, but if i rate limit my proxy it works - but for all users. is there any solution to it that i can rate limit any user with WCCP turned on? urgent help needed.
Note: i'm using real IP, no natting. and i'm rate limiting inbound traffic to gi 0/0.
Thanks.
05-05-2008 06:28 AM
To configure committed access rate (CAR) and distributed CAR (DCAR) policies, use the rate-limit interface configuration command. To remove the rate limit from the configuration, use the no form of this command
For more information refer:
http://www.cisco.com/en/US/docs/ios/12_2/qos/command/reference/qrfcmd8.html
05-05-2008 06:32 AM
HI Cupid,
Just idea and need to be tested.
I think You can use WCCP redirect-list to deny set of hosts, then rate-limit them.
Please rate helpful posts
Best Regards,
Mounir Mohamed
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: