04-27-2008 09:19 PM - edited 03-05-2019 10:38 PM
04-27-2008 09:43 PM
04-28-2008 12:59 AM
Well Mr. Manjunath,
Native VLAN
When you use the IEEE802.1Q trunkport, all frames are tagged except those on the VLAN configured as the "Native VLAN" for the port. Frames on the Native VLAN are always transmitted untagged are normally received untagged. Therefore, when Access Point is connected to the switchport, the Native VLAN Configured on the Access Point match the Native VLAN configured on the switchport.
Cheers!!!!!!
04-28-2008 04:05 AM
Hi,
Can you please send sample configuration for this concept.
Manju.
04-28-2008 04:09 AM
Manju
The default native vlan is 1. If you wanted to change this you can do the following
int gi2/1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport trunk native vlan 999
The last line sets the native vlan to be 999.
Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: