VG224 SCCP and HuntGroup on CCM 6.1

Unanswered Question
Apr 27th, 2008

Hi all,

i configured a VG224 SCCP gateway on CCM 6.1; all features work fine on analog phone except hunt group. If I configure an analog phone as member of hunt group it doesn't ring. I tried to reset it, to remove and add several times but with no success.

Any ideas?

Thanks in advance,


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
hanson.stanley Mon, 04/28/2008 - 04:52


I am sorry if i am disturbing you..but im completely stuck with this...Can you help me....????

I am trying to configure a VG224 with a CCME3.3 router.I need call transfer facility from analog phones that r connected to this VG224.I am configuring VG224 as a SCCP gateway.

i have tried to configure sccp in VG224.what i have done in VG224 is ;

#conf t

#sccp local

#sccp ccm identifier 1 version 3.3


#sccp ccm group

#associate ccm 1 priority 1


When i have typed the "#show sccp" command;

this message shows....

"sccp parameters are not activated (dspfarm profiles)or not associated with ccm group"

I have dsp module in CCME router..

then i came to know that dsp farms r to be created and to be associated to the ccm group...

I have gone through the materials..but still i have doubt on integrating...

Can anyone please help me with the detailed configuration??

I am stuck with this..

please please please help me with this....

Thanks in advance.............

DANIEL COHEN-LAROQUE Tue, 11/18/2008 - 13:38

Hello Stefano,

I just face same problem, but with a 2800 IOS using stcapp feature (same as VG224).

By this time, have you found out the problem?

Stefano Amici Tue, 11/18/2008 - 23:12


I'm sorry but I didn't solve the issue; I found a workaround using an ATA to connect that analog phone.

Stefano Mon, 12/01/2008 - 04:37


The VG224 ports are "logged out" of Hunt Groups by default.

If you put a tick in the "Logged into Hunt Group" box at the Device Level on the VG224 that will fix it.

Kind Regards



This Discussion