04-28-2008 12:56 AM - edited 03-05-2019 10:38 PM
what's the meaning of this error and how can i fix it ?
Thanks
04-28-2008 02:17 AM
look for a physical loop in ur switch.
there must be some miscabling causing a loop.
Try sh cdp neighbor, and u might just see that on a given port ur neighbor is the switch itself.
HTH
Sam
04-28-2008 05:48 AM
Sometimes its caused on the interfaces connected to the IP Phones.
If you find that the cable is fine, disable the keepalive on the switch interface.
-> Sushil
04-28-2008 07:53 PM
I have seen this error on fiber trunks between switches, causing the trunk port to shut down.
According to Cisco, it is caused by a keepalive entering the same port it left from.
As mentioned earlier, removing the keepalive will solve the problem, and is the default (no keepalive) on later OS revisions for the Gigabit ports requiring a GBIC.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: