×

Warning message

  • Cisco Support Forums is in Read Only mode while the site is being migrated.
  • Cisco Support Forums is in Read Only mode while the site is being migrated.

ADSL to GigEthernet

Unanswered Question

Hello,

Guys i need someinput. I have got a Cisco 2621-XM router with IOS "flash:c2600-js-mz.123-19.bin". I am trying to have the connection from my ADSL Router to the Gig-E port Connection on the Cisco GSR.


Following is my CE config. Has anyone done any type of testing. Also one thing, i tried and couldn't do is " bundle enable" command. Not even sure if this IOS supports it. i tried to configure it in Gloabl Mode, under ATM0/1 also under PVC0/XX but it didn't take it. Any suggestionsss.....


bridge irb


interface ATM0/1

no ip address

ip mtu 1482

ip pim nbma-mode

ip pim sparse-mode

load-interval 30

no atm ilmi-keepalive

dsl operating-mode auto

bridge-group 1

pvc 0/66

ubr 384

inarp 1

encapsulation aal5snap

max-reserved-bandwidth 100



interface BVI1

mac-address X.X.X

ip address X.X.X.X 255.255.255.252

no ip proxy-arp


bridge 1 protocol ieee

bridge 1 route ip



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
paolo bevilacqua Tue, 04/29/2008 - 08:08
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Hi, first of all, the ip commands that you have under atm0/1 will not have any effect because the interface doesn't have Ip enabled. If you really need these commands, put them under BVI1.


Second, why do you want bundle command?

Actions

This Discussion