Hello everybody,
I give you my problem:
My ultimate goal is to have a load-balancing using one router 2811(two WAN interfaces and one fastethernet), for that I use route-map.
For the moment something is not implemented, Indeed, if my WAN interface is UP but unfunctional,the router will continue to load-balance ...
That's why I would like to use track which permit,if an inteface is unfonctional, redirect all traffic on the second.
I find many solution with HSRP, but I don't want to use it.
I can't use BGP too: it's impossible for me to configure my ISP's routers.
I can't use Linux ^^ .
Someone would have an idea ?
Thank for your answers
My config:
interface FastEthernet0/0
ip address 192.168.1.254 255.255.255.0
ip nat inside
ip virtual-reassembly
duplex auto
speed auto
!
interface ATM0/0/0
ip address dhcp
ip nat outside
ip virtual-reassembly
no atm ilmi-keepalive
dsl operating-mode auto
pvc 8/35
oam-pvc manage
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
!
interface ATM0/1/0
ip address dhcp
ip nat outside
ip virtual-reassembly
no atm ilmi-keepalive
dsl operating-mode auto
pvc 8/35
encapsulation aal5mux ppp dialer
dialer pool-member 1
!
!
interface Dialer0
ip address negotiated
no ip unreachables
ip nat outside
ip virtual-reassembly
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap callin
ppp chap hostname ********@neuf.fr
ppp chap password 7 ***************
!
interface Dialer1
ip address negotiated
no ip unreachables
encapsulation ppp
dialer pool 1
dialer-group 1
ppp authentication chap callin
ppp chap hostname fti/***********
ppp chap password 7 ************
!
ip route 0.0.0.0 0.0.0.0 Dialer0
ip route 0.0.0.0 0.0.0.0 Dialer1
!
!
ip http server
ip nat inside source route-map RouteMap1 interface Dialer0 overload
ip nat inside source route-map RouteMap2 interface Dialer1 overload
!
route-map RM2 permit 10
match ip address name MonLan
match interface ATM0/1/0
!
route-map RM1 permit 10
match ip address name MonLan
match interface ATM0/0/0
!
