Hi All,
I have just installed the catalyst with a secondary supervisor engine. I log into the secondary to see the following error message.
Error-2-Console> sh mod
Mod Slot Ports Module-Type Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
2 2 2 1000BaseX Supervisor WS-X6K-SUP2-2GE yes error
Mod Module-Name Serial-Num
--- -------------------- -----------
2 SAD05060677
Mod MAC-Address(es) Hw Fw Sw
--- -------------------------------------- ------ ---------- -----------------
2 00-01-c9-da-0f-f6 to 00-01-c9-da-0f-f7 2.17 7.1(1) 8.6(1)
00-01-c9-da-0f-f4 to 00-01-c9-da-0f-f5
00-01-c9-da-0f-f6 to 00-01-c9-da-0f-f7
Mod Sub-Type Sub-Model Sub-Serial Sub-Hw Sub-Sw
---- ----------------------- ------------------- ----------- ------ ------
2 L3 Switching Engine II WS-F6K-PFC2 SAD050601U1 1.6
Error-2-Console> sh ver
Software, Version NmpSW: 8.6(1)
Copyright (c) 1995-2007 by
NMP S/W compiled on Feb 14 2007, 17:33:18
System Bootstrap Version: 7.1(1)
System Boot Image File is 'bootflash:RTSYNC_RTSYNC_cat6000-sup2k8.8-6-1.bin'
System Configuration register is 0x2102
Hardware Version: 0.0 Model: Serial #:
Mod Port Model Serial # Versions
--- ---- ------------------- ----------- --------------------------------------
2 2 WS-X6K-SUP2-2GE SAD05060677 Hw : 2.17
Fw : 7.1(1)
Fw1: 6.1(3)
Sw : 8.6(1)
Sw1: 8.6(1)
WS-F6K-PFC2 SAD050601U1 Hw : 1.6
Sw :
DRAM FLASH NVRAM
Module Total Used Free Total Used Free Total Used Free
------ ------- ------- ------- ------- ------- ------- ----- ----- -----
Uptime is 0 day, 0 hour, 3 minutes
Error-2-Console>
what could possily wrong. Initially after inserting all went well with the images getting synchronized but when i did a supervisor switch it crashed. there are absolutely no machines connected.
Thanks in advance,
subra